- Joined
- Jul 20, 2017
- Messages
- 396
- Reaction score
- 167
- Location
- Solihull
- Hive Type
- National
- Number of Hives
- 9
He turns them inside out so they are white
Top tip. If only Amazon showed an inside out view.
He turns them inside out so they are white
Look what's on the way!!!Its certainly not a nice experience ! .
Layer up on next visit and goodluck
Okay not seen any response saying how to handle this. So here goes. Go back and put a stand 5 - 10 metres away. Then place the brood box on this stand with the entrance facing away from where it was. Then put an empty super on a new floor with a roof where the old box was. Leave for at least 3 hours. The flying bees will then go out and go back into the super. This will give you hopefully a lot less bees to deal with and to sting you. As others say clean gloves, smoke and leave for a few minutes and clean bee suit. Then you need a plan, e.g. find and kill queen. Then merge back, leave 5 days go back destroy all queen cells and put a frame of eggs in from a colony you like, go back 5 days later leave the number of queen cells you want and hopefully a month or so later nice colony or if you have access to another queen just replace her.Well for the first time ever I experienced an angry swarm. I have three hives and have never before in 10 years beekeeping had an angry swarm. I never had to use smoke as the bees were always calm and well behaved, I had only read about angry hives. Until today.
I opened my third and biggest hive last, I wanted to check if it had any indications for swarming. I got the first and then second super of and took a brood frame out when the bees started to seriously attack. They were determined to sting and unfortunately the managed to sting me quite a few times through my leather gloves. Normally I wear two pairs of gloves but hadn't this time.
I managed to fire everything back together even though I just wanted to run!!
I left out one frame from the brood box as I forgot to put it back in my panic. I was quite shaken by this as I do get quite a dramatic reaction to stings. I had about 10 in the end on my hands.
Now I have to take a deep breath and go back down tomorrow to check them out and see if it was a one off or they have turned bad. It was about 430 pm when I checked them which is later than I usually do but the other two hives were fine. If they are the same tomorrow I guess I have to find the queen and get rid of her and buy a new one.
I watched one beek rip off a plastic queen excluder and shake it violently to get rid of the bees. That hive turned out to be queenless….. she’s probably in a bush somewhere wondering what happened.I always give them a couple of chances before starting to think about a new queen .. and I have to be honest - I've seen colonies that their beekeeper has described as 'horrible' that, when I inspected them, were perfectly reasonable ... Whilst I don't think that the bees in this thread are the results of the way the beekeepers are inspecting them I have seen beekeepers who are far too hasty, bang boxes about, roll bees when they take the frames out ... and then wonder why their bees are attacking them !
Just the ticket although no good for us gals unless they do a smaller size. It’s not always easy to find small gloves (6.5 - 7)I have to admit ... after my initial trial (first week of being a real if not proficient beekeeper) of the welding gloves sold (or at times given away) by beekeeping clothing suppliers I realised their limitations ... fine for allowing visitors to watch inspections knowing they are pretty bomb proof but as a useful glove to try and do manipulations ... total disaster ! I rapidly moved to 'Marigolds' of one sort or another - I've tried a huge variety over the years ... some better than others - some I use with nitriles over the top for the covenience and ability to put on a clean pair ...
My present favourite is Ansell Touch n Tuff 92-605 (recommended by a number of forum members and I think they really are the dog's ...Not the cheapest but they really are very good.
https://www.amazon.co.uk/Ansell-Tou...fix=ansell+touch+n+tuff+92-605,aps,297&sr=8-2
Based on your description of the bees, and your reaction to stings, I'd ignore this, for this colony. Longer term certainly worth trying nitriles, but this thread is about these bees.I'd ditch those leather gloves now as well - they will be stinking of attack pheromone.
Well for the first time ever I experienced an angry swarm.
Find and kill queen. Then merge back, leave 5 days go back destroy all queen cells and put a frame of eggs in from a colony you like, go back 5 days later leave the number of queen cells you want and hopefully a month or so later nice colony or if you have access to another queen just replace her.
Yes, I've seen that as well ... In the days when I had solid plywood crownboards I would occasionally find the queen on the underside of the crown board when I took it off ! Easy to lose a queen that way ... Since I've had clear crown boards it doesn't happen any more - I assume that the light coming in, when I take the roof off, drives her down onto the frames.I watched one beek rip off a plastic queen excluder and shake it violently to get rid of the bees. That hive turned out to be queenless….. she’s probably in a bush somewhere wondering what happened.
I think this is over reaction after one bad inspectionOkay not seen any response saying how to handle this. So here goes. Go back and put a stand 5 - 10 metres away. Then place the brood box on this stand with the entrance facing away from where it was. Then put an empty super on a new floor with a roof where the old box was. Leave for at least 3 hours. The flying bees will then go out and go back into the super. This will give you hopefully a lot less bees to deal with and to sting you. As others say clean gloves, smoke and leave for a few minutes and clean bee suit. Then you need a plan, e.g. find and kill queen. Then merge back, leave 5 days go back destroy all queen cells and put a frame of eggs in from a colony you like, go back 5 days later leave the number of queen cells you want and hopefully a month or so later nice colony or if you have access to another queen just replace her.
I remember a lecture at sea school - never react to incomplete or scanty information. Which is what we see here not really useful 'advice' IMHObased on your description of the bees, and your reaction to stings, I'd ignore this, for this colony.
Eric ,and the ending of OSR (which contains an addictive poison) can turn bees murderous
I stand by what I said.I think this is over reaction after one bad inspection
I remember a lecture at sea school - never react to incomplete or scanty information. Which is what we see here not really useful 'advice' IMHO
Like many newbies I bought myself leather gloves as you don’t know any better at that stage and all you know is that bees can sting! I always got stung a lot on the gloves probably as a combination of bees being squished because I couldn’t feel them and then the pheromones remaining in the leather (even though I did wash them). Now I wear tight fitting nitriles or marigolds and as I can feel what I’m doing, am rarely stung. Getting small sizes though is quite tricky so if I find some I buy in bulk.Leather gloves are unhygienic, untactile, and you can still get stung through them! For stingy hives I now use these from Simonthebeekeeper. Buzz Work Wear Latex Gloves
Very thick (almost solid) latex which I have never been stung through. As well as being stingproof you can properly wash them between hives. Only disadvantage is you have no sense of touch, but for ‘nasty’ hives they’re a Godsend.
However for most inspections I use these - similar to some mentioned above but a tad thicker. Ansell Microflex 93-260 Disposable Nitrile/Neoprene Gloves, Chemical Resistant, Industrial, Mechanics and DIY use, Green, Size L (8.5-9) (6 Units) https://smile.amazon.co.uk/dp/B07ZQ...i_i_BA4AJXEAXR51G3APDCB3?_encoding=UTF8&psc=1
Although around £1 a pair, they can be washed between hives and last much longer than normal disposables.
I intuitively feel that bees don't like mobile phones. I'd put mine in airplane mode if I was near the hive. Those things emit really high RF frequencies.Do you not get any issues with the gloves being black?
My bees seem to gun for anything black or perceived as black to them such as the red handle on an old hive tool and my mobile phone sticking out of my packet.
always have my phone in my pocket when inspecting and I sometimes take pictures when the hive is open. Bees are not bothered at all by it.I intuitively feel that bees don't like mobile phones
Enter your email address to join: