Extractor issues

Beekeeping & Apiculture Forum

Help Support Beekeeping & Apiculture Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Ah the rod on the extractor basket does not have a hole at the top - I suspect that part just have sheared off and be stuck in the green bit.
Does the top of the rod have a flat machined finish? If it had sheared off you would see stress marks in the metal.
 
Again thanks everyone - I assume that what I thought was the hole for a roll pin is actually the roll pin itself and that it has sheared in two with part still left - pictures of each end attached. So all I need to do is remove that bit that remains and find a replacement. Good tip re drill bit - I'll see if I have any small enough.
 

Attachments

  • 1653290231611307484901.jpg
    1653290231611307484901.jpg
    389.2 KB
  • 1653290255269647134416.jpg
    1653290255269647134416.jpg
    401.9 KB

Latest posts

Back
Top