Looks like you have the same spinner as me and made the same mistake I did first time extracting….
I wrecked a few combs before I realised what I was doing wrong.
I digest
1) if you can get the frames in they fit..
2) don’t expect them to fit snug or just right so long as they don’t drop all the way down and through. Just ballence them on bottom wire and tillt to the side.
3) spin
slower especially when the frame is full and Hevey …
4 ) only try to get some of the honey out to start.
you don’t have to go as fast or for as long as you think.
You can spin both ways … one way works a bit better than the other depending on whether the top of the frame is on your right or left when you look down on it
5) what looks like little streaks/splashes of honey on the side of the drum is a lot more than you think
6) When half of honey is out of side 1 turn frame around and spin half out of Side 2 Still going slow
7) once half of side 2 is out you can speed up and get the rest out of the honey out of side 2 before turning the frame around or over again and getting the remaining honey out of side 1 .
8) don’t expect to get all the honey out.
9) once you get a feel for full very full and heavy light frames / thick thin honey or after 20 or so frames you can miss out some steps but never spin too fast when frame is full on one side..
Happy spinning