goodbobby
House Bee
- Joined
- Jul 12, 2009
- Messages
- 104
- Reaction score
- 0
- Location
- Sanderstead Surrey
- Hive Type
- 14x12
- Number of Hives
- 5+
After 8 years beekeeping I thought I had a passable grasp of the subject, but it’s a bit like golf….when you think you are coping; it turns round and kicks you in the rear end!
I began 2014 with 4 over-wintered colonies in 14 x 12’s all descended from my original Buckfast nuc purchased in 2006. Historically, I have never needed to buy in a queen and “Artificially Swarm” every May/June for swarm control
I normally start weekly inspections in early April so that I am up to speed in the following six weeks or so to carry out swarm control. This April through serious family illness I had to miss out a two week period and could only inspect yesterday. On doing so I was amazed to find that all four hives had swarmed! They all contain open and closed queen cells and are crammed with stores and brood. One hive has so much stores and brood that it is currently impossible to manipulate without the frames breaking apart under the weight!
My past beekeeping has run fairly smoothly so I am really unsure what to do now and I am certainly in new territory. I have supered each hive to give more room but have not reduced the numbers of queen cells. At this late stage is there any merit in doing so and why? It is still early in the season so helping the colonies get back to full strength is the priority but I am concerned that further cast swarms could result from the current circumstances?
Any advice would be very much appreciated…………………………………..
I began 2014 with 4 over-wintered colonies in 14 x 12’s all descended from my original Buckfast nuc purchased in 2006. Historically, I have never needed to buy in a queen and “Artificially Swarm” every May/June for swarm control
I normally start weekly inspections in early April so that I am up to speed in the following six weeks or so to carry out swarm control. This April through serious family illness I had to miss out a two week period and could only inspect yesterday. On doing so I was amazed to find that all four hives had swarmed! They all contain open and closed queen cells and are crammed with stores and brood. One hive has so much stores and brood that it is currently impossible to manipulate without the frames breaking apart under the weight!
My past beekeeping has run fairly smoothly so I am really unsure what to do now and I am certainly in new territory. I have supered each hive to give more room but have not reduced the numbers of queen cells. At this late stage is there any merit in doing so and why? It is still early in the season so helping the colonies get back to full strength is the priority but I am concerned that further cast swarms could result from the current circumstances?
Any advice would be very much appreciated…………………………………..