Shop deals on ebay
BS Honey Bees
shop deals on amazon
Beekeeping & Apiculture Forum

Help Support Beekeeping & Apiculture Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
9 - prepare a piece of 9mm ply to separate the brood chamber from the feeder. Again, the sides should be at 76 degrees. Remember to take into accoun
12 - prepare some top bars with a groove cut in them to take foundation starter strips.
11 - bore a hole from the outside of the box, through the end panel for the brood chamber. I used a 20mm bit for this.
10 - if made well, this should be push-tight into the box, no doubt helped by the poor quality polystyrene which has a little bit of 'give' in it.
9 - prepare a piece of 9mm ply to separate the brood chamber from the feeder. Again, the sides should be at 76 degrees. Remember to take into accoun
8 - fit the end pieces. No need for glue or anything like that if they've been made a good fit.
7 - modify the end plates with a couple of scrap block arranged to allow the "sides" to be at an angle of 76 degrees (dimensions from the Kieler and t
6 - bore four holes in the base using a 20mm bit and prepare an offcut of OMF mesh to prevent the bees having access to the el cheapo polystyrene. Th
fatshark

9 - prepare a piece of 9mm ply to separate the brood chamber from the feeder. Again, the sides should be at 76 degrees. Remember to take into accoun

There are no comments to display.

Media information

Album
DIY mini nuc/mating hive
Added by
fatshark
Date added
View count
392
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top