Advertise with us
BS Honey Bees
Shop deals on ebay
Beekeeping & Apiculture Forum

Help Support Beekeeping & Apiculture Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
8 - fit the end pieces. No need for glue or anything like that if they've been made a good fit.
11 - bore a hole from the outside of the box, through the end panel for the brood chamber. I used a 20mm bit for this.
10 - if made well, this should be push-tight into the box, no doubt helped by the poor quality polystyrene which has a little bit of 'give' in it.
9 - prepare a piece of 9mm ply to separate the brood chamber from the feeder. Again, the sides should be at 76 degrees. Remember to take into accoun
8 - fit the end pieces. No need for glue or anything like that if they've been made a good fit.
7 - modify the end plates with a couple of scrap block arranged to allow the "sides" to be at an angle of 76 degrees (dimensions from the Kieler and t
6 - bore four holes in the base using a 20mm bit and prepare an offcut of OMF mesh to prevent the bees having access to the el cheapo polystyrene. Th
5 - two end plates built from 3mm ply.
fatshark

8 - fit the end pieces. No need for glue or anything like that if they've been made a good fit.

There are no comments to display.

Media information

Album
DIY mini nuc/mating hive
Added by
fatshark
Date added
View count
409
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top