Shop deals on ebay
BS Honey Bees
Advertise with us
Beekeeping & Apiculture Forum

Help Support Beekeeping & Apiculture Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
15 - almost completed. The fondant chamber is a little narrow perhaps, but that's a restriction imposed by the size of the hole in the polystyrene bo
15 - almost completed. The fondant chamber is a little narrow perhaps, but that's a restriction imposed by the size of the hole in the polystyrene bo
14 - fit runners and spacer blocks for the top bars. Use 35mm centre to centre spacing. Hold everything in place with wood glue.
13 - line the entrance hole with an offcut of 20mm plastic piping, flush at both ends. I used hot melt glue to fix the pipe in place. This prevents
12 - prepare some top bars with a groove cut in them to take foundation starter strips.
11 - bore a hole from the outside of the box, through the end panel for the brood chamber. I used a 20mm bit for this.
10 - if made well, this should be push-tight into the box, no doubt helped by the poor quality polystyrene which has a little bit of 'give' in it.
9 - prepare a piece of 9mm ply to separate the brood chamber from the feeder. Again, the sides should be at 76 degrees. Remember to take into accoun
fatshark

15 - almost completed. The fondant chamber is a little narrow perhaps, but that's a restriction imposed by the size of the hole in the polystyrene bo

There are no comments to display.

Media information

Album
DIY mini nuc/mating hive
Added by
fatshark
Date added
View count
423
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top