Shop deals on ebay
shop deals on amazon
BS Honey Bees
Beekeeping & Apiculture Forum

Help Support Beekeeping & Apiculture Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
14 - fit runners and spacer blocks for the top bars. Use 35mm centre to centre spacing. Hold everything in place with wood glue.
15 - almost completed. The fondant chamber is a little narrow perhaps, but that's a restriction imposed by the size of the hole in the polystyrene bo
14 - fit runners and spacer blocks for the top bars. Use 35mm centre to centre spacing. Hold everything in place with wood glue.
13 - line the entrance hole with an offcut of 20mm plastic piping, flush at both ends. I used hot melt glue to fix the pipe in place. This prevents
12 - prepare some top bars with a groove cut in them to take foundation starter strips.
11 - bore a hole from the outside of the box, through the end panel for the brood chamber. I used a 20mm bit for this.
10 - if made well, this should be push-tight into the box, no doubt helped by the poor quality polystyrene which has a little bit of 'give' in it.
9 - prepare a piece of 9mm ply to separate the brood chamber from the feeder. Again, the sides should be at 76 degrees. Remember to take into accoun
fatshark

14 - fit runners and spacer blocks for the top bars. Use 35mm centre to centre spacing. Hold everything in place with wood glue.

There are no comments to display.

Media information

Album
DIY mini nuc/mating hive
Added by
fatshark
Date added
View count
410
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top