hole punch for queen excluder

Beekeeping & Apiculture Forum

Help Support Beekeeping & Apiculture Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

David1976

New Bee
***
Joined
May 30, 2016
Messages
65
Reaction score
40
Location
East lothian
Hive Type
14x12
Number of Hives
25
is there such a thing as a punch that can be used to cut holes in plastic crown boards to effectively make it a queen excluder?

if so where sells them? I have read that the holes need to be around 4.8mm max and a hole punch is just over 5mm so slightly large.
 
Last edited:
Can you not just buy a plastic excluder and cut to size
 
They are not see through like perspex though so that would defeat the purpose.
you can see through the holes, in my experience that will be sufficient, if you're down to the QX you'll be quickly taking it off to complete the inspection any way.
 
Perspex with so many slits will be fragile and crack esp when stuck down, it sounds like something that's wanted but tbh not really practical when as said you can much get the same using existing ones available.
 
Last edited:
Payne’s do see through plastic QX for their nucs I’m sure. I have two.
Edit. I just checked. They don’t they are slotted steel now.
 
They are not see through like perspex though so that would defeat the purpose.

I've never used cover boards for the 2in1 nucs, had them since they came out - never seen a queen in the feeder. Good luck finding what you need.
 
I am sure I have some clear plastic queen excluders.... but by the time they have been on the colony for a few weeks are not exactly see through.... some years old so could have been purchased from Park Beekeeping in Blackheath?????#
Have a phone around
Chons da
 
is there such a thing as a punch that can be used to cut holes in plastic crown boards to effectively make it a queen excluder?

if so where sells them? I have read that the holes need to be around 4.8mm max and a hole punch is just over 5mm so slightly large.

Won't that make the edges sharp on the bees wings?
 
4.8 mm drill is basicly a std size anyway and readly avalible not that id recomend drilling it.

the only effective and accurate way i can think of for makeing them is waterjet cutting. but your going to get a low of QX's out of a sheet
 
4.5mm drill bit and a needle file? (or just a 4.8mm drill bit from specialist supplier).
3/16 inch = 0.1875 inch = 4.7625 mm.

If you need to drill holes of this size, for bees to climb through, it would be beneficial (to the bees, at least) if the sharp edges of the holes were polished smooth. This can be achieved by buffing the sharp edges with a wire buff fitted to a bench grinder. Alternatively, a wire brush wheel could be used with an electric drill. Just make sure that the direction of movement of the wire bristles is from the centre of the hole, towards the edges of the hole. You would need to do this for the complete circumference of each hole, and also from both sides of the metal sheet.
 

Latest posts

Back
Top